Deliveries, loading and unloading present some of the most dangerous transport activities within a woodworking business. Many accidents involve people being struck by a vehicle, being struck by stock falling from a vehicle or people falling from vehicles during stock access/securing.

Segregation and Location
  • Loading and unloading should be carried out away from pedestrians in a designated area wherever possible. Use signage to increase awareness.
  • The driver should wait in a safe area whilst forklift truck loading and unloading takes place.
  • Loading and unloading should only be conducted on firm, level ground and should be clear of overhead cables, pipes, or other dangerous obstructions. Be sure that the working area is protected against bad weather as far as possible as strong winds can be particularly dangerous.
The vehicle 
  • Before loading and unloading, ensure vehicles have their brakes applied and any stabilisers or outriggers are properly positioned – the vehicle needs to be as stable as possible.
  • Always check the floor of the vehicle before loading to ensure it is safe to load. Look out for debris or broken boarding.
Shifted loads
  • Loads can shift in transit so assess stability of the load before removing any restraints. 
  • Determine a safe system of work for unloading (there may be different systems required depending on what is being unloaded). 
Avoiding falls 

Falls from vehicles is very common, often caused by slipping while walking on loads, tripping on ropes or torn sheets or falling when climbing onto or off the vehicle. 

Where lorry bed access is unavoidable, you should always make sure you:

  • Use steps and handholds provided on the vehicle. Where these aren’t available or accessible, a footed single section ladder should be used with a minimum of 3 points of contact. Mudguards and wheels should never be used. This also applies when getting down from the vehicle, never jump down!
  • Any trip hazards such as loads, straps, bearers, and packing materials should be cleared before access.
  • When on the lorry bed, always face the direction you are walking and pay attention to the stability and grip of the surface you are walking on. Standing on the product should be avoided as far as possible. Be sure to take extra care in wet or icy conditions.
  • Always wear a hard hat with restraining device when working on a vehicle bed and keep a safe distance away from the edge. 
  • Check you are not stepping into the path of a moving vehicle before climbing down from the vehicle.
Securing Loads
  • Loads can be secured using load straps attached to anchor points.  
  • Spread loads evenly and place them as close as possible to the bulkhead or headboard. Load to enable efficient unloading. 
Planning and communication
  • Consider the best time to schedule deliveries and collections to avoid busy times of pedestrian or vehicle movements. Visiting drivers should be given relevant site-specific instructions e.g. where to park, load and unload and where to wait safely. 
  • Deliveries and collections should be well planned, ideally agreeing safety arrangements when the order is placed. Drivers could be provided with simple delivery safety checklists to ensure it is safe to continue with their delivery or collection.
  • Sufficient time should be provided for drivers to check loads are secure, and suitable equipment is made available for loading and unloading. They should be made aware that they can refuse to load or unload if necessary for safety reasons.